1000's of items in stock
Committed to offering the Best Online Prices
FREEPHONE 08082399358, if you've seen it cheaper.
They are suitable for the transfer of liquids containing impurities up to 3 mm in size. The hydraulic components: impeller and nut in nylon, pump body in aluminum, allow it to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3 ° Engel). The liquid temperature must not exceed 70 ° C.
They are commonly used on:
They should normally be installed on a tank with a capacity proportionate to the flow rate, about 4-5 cm from the bottom. It is important to check that the maximum level of liquid in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is recommended to build the tank with compartments, to allow the deposit of sludge before it is fished out by the pump. For different uses it is advisable to consult our Technical Department.
| SKU | YT63IMBAA150 |
|---|---|
| Brand | Sacemi |
| Manufacturer's Part Number | YT63IMBAA150 |
| Model | IMM 63B STEM 150mm - 3 Phase |
| Quick Code | 016796 |
| Warranty | 1 year (terms and conditions apply) |
| Power Supply | 400V 3~ 50Hz |
| kW Rating | 0.37 |
| Max Head | 8 m |
| Maximum Liquid Temperature | 70°C |
| Outlet Connection | 3/4" Threaded |
| Stem Length (Coolant Pumps) | 150mm |
| Pump Technology Type | Centrifugal Impeller Pump |
| Float Switch | No |
